Atag Teppan YakiTY3011M Instructions For Use Manual page 109

INSTALLATION INSTRUCTIONS
Important matters
• Do not use the teppan yaki if it is damaged.
• Never open the casing of the teppan yaki. This may only be
done by a qualifi ed installer.
• Ensure that the fl exes of electrical appliances, e.g. a mixer, do
not touch the hot grill zone.
• Always disconnect the appliance from the electronic power
supply before any repair work is carried out. You do this by
unplugging the appliance, by switching off the fuse(s) or, if
you have a permanent connection, by setting the switch on
the power supply lead to zero.
• Do not use a teppan yaki that is broken or contains cracks.
Switch off the appliance immediately, unplug it from the
power supply to avoid any electrical shocks and call the
service department.
• The connection must comply with all national and local
regulations.
• The appliance must always be earthed.
• The connection cable should hang unobstructed and not run
the risk of being hit by a drawer.
• Ensure that the teppan yaki is built into a fl at worktop.
• The walls and the worktop surrounding the appliance should
be heat-resistant to at least 85 °C.
• The warranty does not cover any damage resulting from a
wrong connection, faulty assembly or improper use.
• The cables connecting the teppan yaki to the control box
should not be bent, twisted or pressed down by an object.
Ensure that this does not happen when unpacking and
installing the teppan yaki.
• If the connecting cable is damaged, it may only be replaced
by the manufacturer, the manufacturer's service organisation
or equivalently qualifi ed persons, in order to avoid dangerous
situations.
• Place a protective plate under the hotplate to prevent
touching of the hot underside of the hotplate.
EN 13
Important matters contents