Atag Teppan YakiTY3011M Instructions For Use Manual page 117

INSTALLATION INSTRUCTIONS
Change zero position knob
If you wish you may turn the control knobs 90° in relation to
the control box so that the zero position of the knob is set in the
right direction. Follow the steps as described below.
Ensure that the appliance is disconnected from the power
supply before you start.
(B)
print plate
(C)
screw
control box
(D)
thermostat/switch
(A)
control box cover
1. Unscrew the cover of the control box and remove the cover (A).
2. Carefully remove the print plates from their supports (B)
and unscrew the thermostat/switch combinations (D) by
loosening the screws (C).
3. Change the position of the thermostat/switch combination.
The fi gure shows a 90° turn to the right from position 1 to
position 2.
4. Ensure that you do not bend the capillary lead of the
thermostat.
EN 21
Top-wood contents
position 1
position 2
turn 90˚