Subscribe to Our Youtube Channel
Related Manuals for AIMS Power GEN3200W120V
Summary of Contents for AIMS Power GEN3200W120V
- Page 1 PORTABLE INVERTER GENERATOR GEN3200W120V IMPORTANT ─ USERS OF THIS EQUIPMENT SHOULD READ AND UNDERSTAND THE MANUAL PRIOR TO USING. KEEP MANUAL FOR REFERENCE. 2018-8-8 (REV:01)
-
Page 2: Table Of Contents
C O N T E N T S SAFETY INFORMATION ........................2 CONTROL & FEATURES........................4 PRE-OPERATION CHECK ....................... 6 OPERATION ............................8 PERIODIC MAINTENANCE ......................12 TROUBLE SHOOTING ........................15 STORAGE ............................16 SPECIFICATION ..........................17 WIRING DIAGRAM ..........................18... -
Page 3: Safety Information
WARNING ! PLEASE READ AND UNDERSTAND THIS MANUAL COMPLETELY BEFORE OPERATING THE GENERATOR. SAFETY INFORMATION EXHAUST FUMES ARE POISONOUS Never operate the engine in a closed area or it may cause unconsciousness and can cause death within a short period of time. - Page 4 CONNECTION NOTES Do not connect the generator to commercial power outlet. Do not connect the generator in parallel with any other generator. SAFETY SYMBOLS Caution - The user should be aware of a general hazard. Dangerous Voltage Flammable Hot Surface - Do not touch.
-
Page 5: Control & Features
CONTROL & FEATURES DESCRIPTION (1) Fuel tank (2) Fuel tank cap (3) Fuel filter (4) Carrying handle (5) Muffler (6) Spark plug (7) Choke lever (8) Recoil starter (9) Fuel cock (10) Brake lever (11) Wheel (12) Oil filler cap (13) Air filter (14) Fuel pump (15) Battery... - Page 6 OIL WARNING SYSTEM FIG.2 When the oil level falls below the lower level, the engine stops automatically. Unless you refill with oil, the engine will not start again.FIG.2 ENGINE SWITCH The engine switch controls the ignition system.FIG.3 ON (run) ① Ignition circuit is switched on.
-
Page 7: Pre-Operation Check
BRAKE LEVER ① ② FIG.7 The function of brake lever is preventing generator moving.FIG.7 ① if the brake lever is not on, the generator can move. ② If the brake lever is on, the generator can’t move. AUTO GEN START FIG.8 The auto gen start controls the ignition system. - Page 8 CHECK ENGINE OIL FIG.10 Make sure the engine oil is at the upper level of the oil filler hole. Add oil as necessary. Remove oil filler cap and check the engine oil level.FIG.10 If oil level is below the lower level line, refill with suitable oil to upper level line.
-
Page 9: Operation
OPERATION FIG.14 The generator has been shipped without engine oil. Fill with oil or it will not start. Do not tilt the generator when adding engine oil. This could result in overfilling and damage to the engine FIG.15 STARTING THE ENGINE ... - Page 10 Electric start 1. Turn the fuel cock lever to the ON position. 2. Turn the choke lever to the│ │position. FIG.20 3. Turn the engine switch to the START position. FIG.20 4. Turn the engine switch to the RUN position. FIG.21 START 5.
- Page 11 OVERLOAD INDICATOR LIGHT The overload indicator light comes on when an overload of a connected electrical device is detected, the inverter unit overheats, or the AC output FIG.25 OVERLOAD voltage rises. The electronic breaker will then activate, stopping power to the generation in order to protect the generator and any connected electric devices.
- Page 12 connection,if the protector is in “OFF” position. CAUTION: Be sure the economy control switch is turned off while charging the battery. FIG.28 STOPPING THE ENGINE 1. Turn off the power switch of the electric apparatus or disconnect any electric devices. FIG.28 2.
-
Page 13: Periodic Maintenance
PERIODIC MAINTENANCE MAINTENANCE CHART Maintenance is important for the best performance and safe operation. Pre-operation Initial Every Every Every Item Remarks check 1 months 3 months 6 months 12 months (daily) or 20 Hr or 50Hr or100Hr or 300Hr Spark Check condition adjust gap and ... - Page 14 ENGINE OIL REPLACEMENT FIG.31 Place the generator on a level surface and warm up the engine for several minutes. Then stop the engine and turn the fuel cock knob to “OFF””. Loosen the screw and remove the cover.FIG.31 Remove the oil filler cap.FIG.32 FIG.32 Place an oil pan under the engine.
- Page 15 CAUTION: FIG.35 The engine should never run without the element; excessive piston and/or cylinder wear may result. CLEANING AND ADJUSTING SPARK PLUG 1. Remove the cover. 2. Check for discoloration and remove the carbon.FIG.35 3. Check the spark plug type and gap. 4.
-
Page 16: Troubleshooting
Remove the carbon deposits on the muffler screen and spark arrester FIG.38 using a wire brush.FIG.38 Re-install the muffler screen. Re-install the cover TROUBLESHOOTING Engine won’t start 1. Fuel systems No fuel supplied to combustion chamber. No fuel in tank….Supply fuel. ... -
Page 17: Storage
STORAGE Long term storage of your generator will require some preventative maintenance to guard against deterioration. DRAIN THE FUEL Remove the fuel tank cap, drain the fuel from the fuel tank Remove the cover, drain fuel from the carburetor by loosening the drain screw. ENGINE Remove the spark plug, pour in about one tablespoon of SAE 10W30 or 20W40 motor oil into the spark plug hole and reinstall the spark plug. -
Page 18: Specification
SPECIFICATION MODEL GEN3200W120V Type Portable Inverter Generator AC Voltage 100V,110V,120V Frequency 60Hz Max. Output 3.2 kW Rated Output 2.8 kW Power Factor DC Output 12V / 5.0A Model XY157F Type Air-cooled, 4 cycle, OHC, Gasoline Engine Bore×Stroke mm×mm 57.4×57.8 Displacement 149.5cc... -
Page 19: Wiring Diagram
WIRING DIAGRAM CONTROL PANEL BLOCK GENERATOR BLOCK FUSE 15A DC 12V OUTPUT DC PROTECTOR 6A WINDING RECTIFIER GROUND TERMINAL DC 5V OUTPUT V-I-W-Hz INVERTER UNIT AC OUTPUT MAIN 5-20R L5-30R WINDING ECO. SWITCH WINDING OUTPUT OVERLOAD IGNITION WINDING LOW OIL IGNITION CONTROLLER ELECTRIC LOCK STEPPER MOTOR ASSY.
Need help?
Do you have a question about the GEN3200W120V and is the answer not in the manual?
Questions and answers