Table of Contents
Advertisement
S E C T I O N
3
....
B A N D I N G
13
Refer to Section 4 Tensioning Tables to
set the correct pressure.
Hold down trigger on air ratchet. The
tool will stall when the system reaches
the correct tension. If red marker is
showing, simply reverse direction of
tool by turning knob on back of air
ratchet head (see inset). Wind tool back
until green, reverse direction again and
continue to tighten.
If required, further calibration can be
achieved with a torque wrench see
photo 11
14
WARNING – Ensure that the green
marker is showing before cutting
the band.
To remove the excess band,
simply take hold of the cutting
handle...
15
...and push upwards
16
Once cut remove tool from
buckle – Installed system
SM-FT-1000 Banding Tool
T O O L I N G
Advertisement
Table of Contents
