Table of Contents
Advertisement
B A N D I N G
For manual tightening attach
handle to the square drive at
the rear of the tool
WARNING – Ensure tool does not
lift away from application
during tightening
Wind handle clockwise until
band is tight. If red marker is
showing, wind handle anti-
clockwise until green, then
continue to tighten the band
To gain high accuracy in tension
fit using torque wrench. Refer to
the tensioning tables to set the
See torque wrench manual for
detailed operating instructions
NOTE – Torque wrench can be
used without handle using the
socket provided
WARNING – Do not operate the
Cutter during tightening
For pneumatic tightening
attach air ratchet to the square
drive at the rear of the tool
and locate in torque reaction
See air ratchet manual for
detailed operating instructions
SM-FT-1000 Banding Tool
T O O L I N G
9
10
11
correct torque
(see step 14)
12
bracket
S E C T I O N
GREEN MARKER -
Indicates tool is at
the start of its travel
3
RED MARKER –
Indicates tool is at the
end of its travel
Advertisement
Table of Contents
