HCL Smart Band SM-FT-1000 Operation, Parts And Safety Manual page 12

Changing the Pawl
1-4
Repeat steps 1-4 in Section 6, Maintenance
5
Remove pin from housing
6
Remove old pawl and insert new pawl
NOTE – Take care to reinsert spring in correct
orientation.
7
Re-fit pin. Reassemble tool as reverse of disassembly
S E C T I O N
Example of a 19mm (¾")
Adaptation Kit
7 B A N D I N G
Adapting
the Tool
Every fitting tool can be adapted to fit
the following sizes of Smart Band:
32mm (1¼"), 25mm (1") & 19mm (¾")
Changing the Front Plate & Blade
1
Ensure cutting handle is in the down position. Remove
Capscrews (4x) using 3mm Allen Key and remove old front
plate
2
Remove existing blade and insert spring into new blade
3
Reassemble tool as reverse of disassembly
SM-FT-1000 Banding Tool
T O O L I N G