Display Assembly - HP Stream 14 Maintenance And Service Manual

Display assembly

NOTE: Spare parts for the display assembly are available at the subcomponent level only. For display
assembly spare part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
Remove the display assembly:
1. Remove the WLAN antennas from the routing path in the computer (1).
2. Remove the four Phillips M2.5 × 5.0 screws (2) that secure the display assembly to the computer.
3. Lift the display assembly from the computer (3).
4. If it is necessary to replace the display bezel:
a. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel releases from the display back cover.
b. Remove the display bezel (4).
The display bezel is available using the following spare part numbers:
L59786-001 for blue models
L59796-001 for white models
L59791-001 for black models
L59801-001 for pink models
36 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
(Preparation for disassembly on page
Bottom cover on page 24).
23).
Battery on page 25).