Removal And Replacement Procedures For Authorized Service Provider Parts; Component Replacement Procedures; Preparation For Disassembly - HP Stream 14 Maintenance And Service Manual

5 Removal and replacement procedures for
Authorized Service Provider parts
IMPORTANT:
provider. Accessing these parts can damage the computer or void the warranty.
NOTE: Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer. See

Component replacement procedures

NOTE: HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
There are as many as 44 screws that must be removed, replaced, and/or loosened when servicing the
computer. Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

See Removal and replacement procedures preliminary requirements on page 18
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
Components described in this chapter should be accessed only by an authorized service
Labels on page 11 for details.
for initial safety procedures.
Component replacement procedures 23