Viewing The Digital Signal Meter; Setting The Time Zone - Toshiba Regza 32CV510U Owner's Manual

Viewing the digital signal meter

You can view the digital signal meter in the ANT/CABLE
digital TV input source only.
To view the digital signal meter:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the Terrestrial menu, highlight Signal Meter,
and press T.
3
Press BbC c to select the antenna input and digital
channel whose signal you want to check. You can choose
from Advanced or Basic signal meter.
Note:
• The physical digital channel number listed in the Signal
Meter screen may not correspond to a virtual TV
channel number. Contact your local broadcasters to
obtain the RF channel numbers for your local digital
stations.
• The signal strength does not change between virtual
channels on the same physical channel.
To close the screen and return to the Terrestrial
menu:
Highlight Done and press T.
To return to normal viewing:
Press O.
32
Chapter 5: Setting up your TV

Setting the time zone

The Time Zone setup will allow you to specify the correct time
zone for your region. This feature will allow the TV to show
the correct time zone information and you can see it displaying
the TV status information (- page 53).
To set the time zone:
1
From the Setup menu, highlight Installation and press
T. A new set of Installation menu icons will appear.
2
Open the Time Zone menu, highlight Time Zone
Setup, and press T.
3
Press B and C c to select the region, highlight Done, and
then press T.
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To set the Daylight Saving Time status:
1
Press B and C c to select Yes or No, highlight Done,
and then press T.