Using The Hdmi Settings Feature; Regza-Link Setup; Hdmi Settings - Toshiba Regza 32CV510U Owner's Manual

To set the REGZA-LINK Setup:
1
From the Setup menu, highlight REGZA-LINK Setup
and press T.
2
Press B or b to highlight Enable REGZA-LINK.
3
Press C or c to select On.
Note: If you set Enable REGZA-LINK to Off, the other
items will be grayed out.
4
Press B or b to highlight the REGZA-LINK setup item
you want to use, and press C or c to select On or desired
mode.
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver
•
5
To save the new settings, highlight Done and press T.
To revert to the factory defaults, highlight Reset and
press T.
52
Chapter 6: Using the TV's features

Using the HDMI settings feature

This menu consists of the following item (new HDMI
capability) and will be grayed out on non-HDMI inputs.
Some HDMI legacy sources may not work properly with your
HDMI TV, please try setting the following option (Lip-Sync
Latency) to Off. Adjusting this setting should allow your
HDMI legacy source to operate properly with your TV.
Note: You must disconnect your source device first before
settings can be adjusted.
Lip-Sync Latency: On
•
This option activates an auto audio/video display timing
adjustment function that allows HDMI source devices to
accurately perform synchronization automatically.
Above HDMI setting needs proper HDMI source device. If
HDMI source products does not support this feature, the TV
may not work properly by activating these features.
Note: If your HDMI connection is capable of 1080p and/or
your TV is capable of refresh rates greater than 60Hz, you will
need a High Speed HDMI cable. Conventional HDMI/DVI
cables may not work properly with this mode.
To set the HDMI Settings:
1
Select the appropriate HDMI input mode (HDMI 1,
HDMI 2, or HDMI 3).
2
From the Setup menu, highlight HDMI Settings and
press T.
3
Press B or b to highlight the item you want to set.
4
Press C or c to select On or Off .
5
To save the new settings, highlight Done and press T.
To revert to the factory defaults, highlight Reset and
press T.