Judo PROFIMAT JPF-A Series Installation And Operating Instructions Manual page 15

5.2.1 Backwashing interval
If cleaning is not performed soon enough,
the result may be damage to the sieve
insert. Large quantities of filtered particles
can deform the sieve fabric and in extreme
case lead to tearing of the sieve fabric.
In addition, larger deposit quantities can
impair the backwashing function mechani-
cally.
Mesh size [mm]
0.03
0.10
0.10 and 0.32
0.32 and 0.5
Selection of the backwashing intervals
1) Dependent on the dirt formation
2) if necessary, securing of the filter acc. to DIN EN 1717
Experience has shown that new installa-
tions in the early stages of installation lead
to increased dirt deposits. In this case, a
more frequent backwashing is necessary.
5.2.2 Setting the backwashing
interval
The factory setting is for a cleaning interval
of one week.
Risk of electric shock!
ELECTRO_NO_HEADER
Disconnect the power supply unit
from the socket.
1701649 • 2019/04
Operation
According to DIN EN 13443-1 backwashing
the device is required at the latest every six
months.
The manufacturer requires a backwash-
ing:
• at least after a month
• if the water pressure drops
• if the filter is visibly dirty
Applications
GP surgeries, laboratories,
photo laboratories
Domestic water technology
in the private and commer-
cial sector
Domestic water technology
Well water
Industrial sector
Air conditioning systems
1. Loosen the four screws of the cover and
2. Set the backwashing interval via con-
3. Place the cover back on and bolt.
JUDO JPF-A
Recommended backwash-
ing interval
24 hours
1 week, 1 month
24 hours, 1 week
24 hours, 1 week
remove the cover.
tacts 2 to 6 of DIP switch S1 (see
Tab. 2: DIP switch S1).
Attention: only one contact may be
switched to the left for setting. The cir-
cuit reacts to incorrect settings with a
continuous signal (see chapter 7).
4 8 24
Hours Hours Hours
DIP switch S1
1 1
Week Month
15