Advertisement
Available languages
Available languages
Removing the Mask
Keep your adjustments! Easily remove the mask by grabbing the headgear back
strap
and slide the headgear forward over your head.
J
Disassembly
1. Cushion: Grasp the pillows cushion platform
Caution: Do not pull on the pillows cushion tips
2. Elbow: Pull from frame
Caution: The elbow
attempt to separate the elbow or swivel from the tube.
Caution: Do not pull on mask tube
3. Frame: Undo the frame tabs
Assembly
Note: The correct position for the elbow
platform
is to point down (
C
1. Elbow: Press into the retaining ring
2. Cushion: Push onto the back of the elbow
Note: The elbow, frame and cushion will fit tightly together without any gaps
. If there are gaps or the cushion angle is low
reattach. The cushion should fit securely on the elbow with the pillows at an
angle towards the nose
3. Frame: Position the frame with the retaining ring
4. Headgear: Position the tube management loop
5. Slide the frame tabs through the headgear slots and fold forward.
Note: The Philips Respironics logo is on the outside of the headgear back strap
when correctly assembled.
J
Philips Respironics System One Resistance Control
Your mask when combined with a Philips Respironics System One device, provides
optimal resistance compensation. This value is identified below and should be set
by your provider.
Size
Setting
S, M, L
.
H
, tube
, and swivel
D
F
and pull through the slots in the headgear.
I
.
X2
and peel from elbow
C
A
are permanently attached. Do not
G
to separate from CPAP tubing.
F
, retaining ring
D
)
.
until all sides are flush.
.
E
L
5
to remove from elbow
, and cushion
E
remove the cushion and
pointing down (
on top.
.
D
.
D
).
Advertisement
