Table of Contents
Advertisement
Step 1: Unpacking
Accessories
Check for the supplied accessories below.
• Audio/Video Cable
• RF Cable for TV
• Remote Control
• Batteries for Remote Control (AA Size)
• User's Manual
* Dispose of batteries according to local environmental
regulations. Do not put them in the household trash.
Step 2: Connecting DVD
Recorder-VCR to the TV using
the RF Cable
To receive television programmes a signal must be
received from one of the following sources:
• An outdoor aerial
• An indoor aerial
• A cable television network
• A satellite receiver
Make sure that both the television and the
DVD Recorder-VCR are switched off before
Note
connecting the cables.
Remove the aerial or network input cable from
1
the television.
Connect this cable to the 75Ω coaxial socket
2
marked
on the rear of your DVD Recorder-
VCR.
Plug the RF cable supplied into the
socket on
3
TV
your DVD Recorder-VCR.
18 - English
Plug the other end of the RF cable into the con-
4
nector previously used for the aerial on the televi-
sion.
To obtain better quality pictures and sound on
your television, you can also connect your
Note
DVD Recorder-VCR to the television via the
SCART cable (see next page) if your televi-
sion is equipped with this type of connection.
Aerial
AUDIO OUT
R
R
L
L
DIGITAL AUDIO OUT
OPTICAL
COAXIAL
VIDEO
TV
ANT
RF cable
Step 3: Connecting the
Scart Cable
Method 1 : Connecting DVD Recorder-
VCR to the TV using the SCART Cable
You can connect your DVD Recorder-VCR to the televi-
sion using the SCART cable if the appropriate input is
available on the television. You thus:
•
Obtain better quality sound and pictures
•
Simplify the setting up procedure of your DVD
Recorder-VCR
•
Regardless of the type of connection chosen, you
must always connect the RF cable supplied.
Otherwise, no picture will be visible on the screen when
the DVD Recorder-VCR is switched off.
•
Make sure that both the television and the DVD
Recorder-VCR are switched off before connecting the
cables.
1. Connect the RF cable as indicated in the previous
section.
2. Connect one end of the SCART cable to the AV1
(EURO AV) socket on the rear of the DVD Recorder-
VCR.
3. Plug the other end into the appropriate connector on
the television.
Aerial
AUDIO OUT
R
R
L
L
DIGITAL AUDIO OUT
OPTICAL
COAXIAL
VIDEO
1
SCART Cable
2
TV
ANT
RF cable
Method 2 : Connecting DVD Recorder-
VCR to a Satellite Receiver or Other
Equipment
You can connect your DVD Recorder-VCR to a
Satellite receiver or other DVD Recorder-VCR using
the SCART cable if the appropriate outputs are avail-
able on the equipment chosen. The following illustra-
tions give a few examples of the connection possibili-
ties.
1. AV1(EURO AV): By means of 21-pin Scart Cable
Plug the SCART Cable with satellite receiver or
other equipment into the AV1 (EURO AV) socket on
the rear of the DVD Recorder-VCR.
After making this connection, select the source by
pressing the INPUT SEL. button for the AV1 input
sources.
2. By means of RF Cable
After making this connection, you must preset the
station received through the satellite tuner.
RF output channel of the satellite receiver should
be adjusted away from channel 60, which is used
by the DVD Recorder-VCR, e.g. re-adjust to chan-
nel 65.
Satellite Receiver or other
Equipment
Aerial Connector
AUDIO OUT
R
R
L
L
DIGITAL AUDIO OUT
OPTICAL
COAXIAL
VIDEO
2
1
TV
ANT
RF cable
English - 19
Advertisement
Table of Contents
