Skoda 5JA 071 126 Fitting Instructions Manual page 14

Basic roof rack
Hide thumbs Also See for 5JA 071 126:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
- 17 -
EN
Advice. Check the hook for the correct position against
the sideplate of the roof. (The bottom surface of the
hook must copy the shape of the roof sideplate -arrow-.)
The lock blocks the eccentric lever.
- 18 -
- Proceed in the same way to fix the rear rack on the roof of the
car.
- Check correct position of all four bottom ends.
- 19 -
- Snap the bottom end cap into the carrying section.
- 20 -
- Lock the bottom end cap lock (the key is in horizontal position),
take the key out and store it.
Disassembling
- 21 -
- Proceed in reverse for disassembling the roof rack.
Caution. When the side door of the vehicle is closed,
one by one unlock and release the levers of all
eccentrics.
When lifting the eccentric lever, brake the movement
of it by your hand all the way whilst holding the
bottom end of the rack at the vehicle roof with your
other hand.
- 22 -
- Open the side door of the car and eject the centring pins of the
hook off the riveting nut holes.
14
- 23 -
- Lift the roof rack carefully to such height that the hooks are
beyond the rood sideplate.
- Put the rack aside to a suitable place.
Remove the support from the roof of the vehicle with
the utmost care to prevent damage to the paintwork.
- 24 -
- Press the eccentric levers down and put the rack to a suitable
place in your garage or cellar, as the case may be.
- We recommend that the roof rack caps are stored separately.
When the cap is mounted on an non-fitted rack, it is pushed away
by a return spring that might cause malformation of the cap in
case of a long-term exposure.
- 25 -
- The maximum loading capacity of the vehicle roof, the rack
included, is 75 kg.
Operating instructions
Before the drive always check the roof rack for correct position and
the load for proper securing and fastening.
If you need to mount accessories holders on the roof rack (bicycle
holder, ski holder, etc.), take out the sealing profile of the T-groove
and fix the accessories using T-bolts.
Advice. Using U-stirrups to mount the accessories
might cause damage to the surface finish of the roof
rack crosspiece. This fact is not a reason for a
complaint.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

5e5 071 1265jj 071 1266v6 071 126

Table of Contents