I - Initial Verification; Unpacking The Clock; Cleaning - Bodet Profil 730 Installation And Operation Manual

I - INITIAL VERIFICATION

Thank you for choosing a BODET clock. This product has been carefully designed for your
satisfaction based on ISO9001 quality requirements. We advise you to read this manual
thoroughly before attempting to manipulate the clock.
Keep this booklet during all the life of your clock, so that you can refer to it each time it will be
necessary.
Bodet accepts no responsibility for accidents resulting from any use not conforming with
the above provisions.
Any modification to the product will invalidate the guarantee.

1.1 Unpacking the clock

Unpack with caution and check the contents of the packaging. It must contain :
• l'horloge Profil et ce manuel,
• 1,5 volt battery, type LR 6 for battery version,
• A cleaning kit (impregnated antistatic cloth),
• the clock support which is delivered separately. It is delivered with the outdoor and the 230V
AFNOR/Irig-B time signal reception clocks. It is an option for internal clocks.
Versions : a descriptive label is fixed to the back of the clock :
MN 24V = the clock is a receiver driven by a master clock that sends minute impulses on a
parallel line.
SEC 24V = the clock is a receiver driven by a master clock that sends second impulses on a
parallel line.
AFNOR TBT = the clock is a receiver driven by a master clock that sends AFNOR NFS-
87500A time coded messages ; it is supplied in low voltage 6-24 V.
DHF PILE = the clock is radio-synchronised by a DHF transmitter and battery operated (2
batteries LR14).
DHF PILE = the clock is radio-synchronised by a DHF transmitter and battery operated (2
batteries LR6).
DHF TBT = the clock is radio-synchronised by a DHF transmitter ; it is supplied in low
voltage 6-16 V DC.

1.2 Cleaning

Use an antistatic product of similar type to the one shipped in the original packaging. Never use
alcohol, acetone or any other solvent liable to damage the casing and filter on your clock.
EN
11