Step 2 3 Point Hook Up - Mahindra BBSST4 Owner's Manual

STEP 2
3 POINT HOOK UP
IMPORTANT:
A 3 point category 1 hitch is required.
The lower arms of the 3 point hitch must be stabilized
to prevent side to side movement. Most tractors have
sway blocks or adjustable chains for this purpose.
Slowly back up the tractor to the Box Scraper and use
the tractor's 3 point hydraulic control.
WARNING
TO PREVENT INJURIES:
Park the vehicle on a flat surface in a well ventilated
area.
Disengage the P.T. O.
Apply parking brake.
Stop the engine and remove the ignition key.
Wait until all moving parts have stopped before
leaving the driver's seat.
FOR SD MODEL
Attach tractor's lower arms (item 1) on the pins (item
2) and secure with lynch pins (item 3)
Connect top center link (item 4) to the upper hitch
using a pin and hairpin (item 5) as shown in figure 3a.
FOR HD MODEL
Attach tractor's lower arms (item 1) to frame of
assembled box scraper with two pins (item 2) and
secure with lynch pins (item 3)
Connect top center link (item 4) to the upper hitch
using a pin and hairpin (item 5) as shown in figure 3b.
Return to the tractor and slowly operate the tractor's 3
-point hydraulic control up and down to check for
clearance between tires, frame drawbar, etc.
Move or remove the draw bar if it interferes with the
Box Scraper.
Manually adjust one of the two lower lift arms up or
down to level the Box Scraper from left to right.
Manually adjust the length of the top-link to level the
Box Scraper from front to rear.
Ensure that the lower lift arms are blocked to prevent
excessive movement.
ASSEMBLY
TO PREVENT INJURIES:
Hooking up equipment to the tractor is dangerous
and can result in serious injury or death. Do not
allow anyone to stand between the tractor and the
Box Scraper while backing up to the equipment. Do
not operate hydraulic 3-point lift controls while
someone is directly behind tractor or near the
scraper.
7
DANGER
Fig. 3a
Fig. 3b