Siemens 5WG1 201-2DBx3 Series Technical Product Information page 7

Gamma arina touch sensor
Installation of mounting frame (F1)
Mount the mounting frame (F1) onto conduit box (G1)
via mounting slots with mounting screws (F2).
Figure 4: Mounting of the frame
F1 Mounting frame
F2 Mounting screws
G1 Conduit box (86 mm X 86 mm)
G2 Mounting slots
Insert KNX connector (H2)
− Wiring the KNX connector (H2).
− Insert the KNX connector (H2) to the touch sensor.
Please be noted the polarity of bus connection with
mark on housing.
Figure 5: Connect KNX connector
F3 Back housing
F4 Front housing
H1 Pin
H2 KNX connector
H3 KNX line
UP 20x, UP 28x/3 and UP 28x/5
Siemens Building Technologies
single
double
quadruple
Installation of main module (F3 together with F4)
Slip the wall switch's main module (F3) together with
(F4) onto the mounting frame and firmly press them to-
gether.
F1
F3
F4
Subject to change without further notice
Technical product information
Figure 6: Mounting of the main module
Mounting frame
Back housing
Front housing
Technical product information
Update: http://www.siemens.com/gamma
Gamma instabus
June 2014
2.16.1.13/7