Advertisement
repeatedly, it will break the traces and the LED's will not work.
If you choose to use the lighted pin option when using a fiber
optic to aim, route the wires around the scope housing to
your fiber. If you are not using a fiber optic to aim, simply un-
plug the white PicoBlade connector carefully, using tweezers
or holding each end, and set aside for later use.
High Setting
Last Shot Fired
Optimum Setting
Shot Counter
Current Pressure
Battery Life
WiFi:
this will change
from a W to an A when
connected to device
• Plug in the micro USB connector from the LED card you
just installed into the port on the SweetSpot labeled (LED)
and secure the cable with supplied zip ties. Be sure to put a
strain relief loop in the usb cord before plugging it in. This will
require a zip tie or tape a few inches back from the connector
so that the cable is secure and then loose for 2 inches to the
port. This allows vibration to be soaked up before it is directed
into the port.
Using the SweetSpot
• Once everything is mounted, secured and plugged into the
correct ports on the SweetSpot. BE SURE to check and make
sure no wires interfere with any moving parts and will not inter-
fere with the arrow leaving the bow. (Pressure Perfect Products
is not responsible for misuse or improper installation.)
• Go to http://sweetspotarchery.com/installation for
installation and instructional videos.
Advertisement
