Advertisement
This forces out any air bubbles and
keeps the sensor secure while it cures
(this tape can be removed in 24hrs
after the glue has completely cured)
(see Fig. 4).
Once you reach the USB connector cut
off the excess tape with scissors. This
will apply even pressure to the sensor.
Leave the electrical tape on and allow
the glue to cure for a MINIMUM of 4
hours (see Fig. 5).
Step 7) After 24 hours you can plug in the micro USB cable from
the SweetSpot being careful to have it turned the correct way.
It does not take much force to plug in the cable. If it is difficult,
double-check that it is lined up correctly.
FIG. 5
FIG. 6
Step 8) If you wish to remove the electrical tape, wait 24 hours.
It is recommended to leave the tape on to protect the sensor. It
is also highly recommended, after the cable is plugged into the
sensor, to wrap the sensor with grip tape for extra insulation so
temperature will not have an adverse affect on it.
Step 9) Route the cable, being sure to avoid any moving parts
(cable slide, arrow, arrow rest, sight) up to the where you will
mount the SweetSpot, securing it with supplied zip ties. There
should be a zip tie 1-2 inches from the sensor to secure the
cable to the bow and prevent the cable from being snagged.
Mounting the SweetSpot, LED card and
plugging in cables
• Use the supplied Velcro strips to secure the SweetSpot
Advertisement
