Advertisement
controller to your sight rod or bow riser. Be sure the cable
from the sensor will reach the sensor port without damaging
the wire.
• Once the SweetSpot is secured to the bow, plug the other
end of the micro USB cable (from the sensor) into to the
port labeled (sensor) on the SweetSpot. It is important to
have strain relief loop on all cables before you plug them into
the SweetSpot. This will prevent excess vibration from dam-
aging the sensor and LED ports when the bow is fired. (We
are not responsible for any misuse or incorrect installation
resulting in damaged products or injuries to one's self
or a bystander.)
• Take your time to determine a location to mount the LED
card. Remember you want to be able to see this at full draw to
reap the benefits of the system (this is personal preference,
but most prefer to mount the LED card inside the scope
housing. Some scope setups allow you to mount the LED
card directly behind the level, which will brighten the level
green or red and helps to see your bubble in dark conditions.
Depending on your field of view through your peep sight, you
may be able to mount the LED card on top of your scope
housing). Be sure the location you choose will not affect the
flight of your arrow.
• Once you have selected a safe and efficient location that
you can see at full draw, clean the surface with an alcohol
prep pad.
• Peel off the double-sided tape from the LED card and press
the LED card down carefully, so as not to break the traces.
You can form the LED card to fit the radius of your scope. Be
sure to only bend the card slightly and only in one direction.
If you bend it in one direction it CANNOT bend the other
direction without damaging the card. If the LED card is bent
Advertisement
