Advertisement
Webserver
The built-in webserver has the following functions:
• View and Save past shots
• View real-time force
• Configure settings
To connect to the webserver, see Section WIFI Connection. On
the webserver, you can see more about your shot by clicking
"5 sec." on the bottom of the page. This shows you the last 5
seconds before you fired – if you were adding pressure, creeping
or maintaining before you fired. You will also see how well you're
holding as the sensor is sensitive enough that the movement will
indtroduce more flex to the riser.
Factory Reset
• Power off device
• Hold [Left] and [Right] while Pressing [Power]
• Wait until "Reset Done" is displayed
• Release Buttons
Note: The WIFI SSID, password, and channel do not get reset on
a factory-reset.
Shot Broke Above High Value
Shot Broke in Optimum Threshold
Shot Marked By Archer (Press Select
On Active Screen to Mark Shot)
Shot Broke Weak Below Optimum
Advertisement
