Advertisement
Advertisement
Table of Contents
Related Manuals for Vortex Razor HD 4000
Summary of Contents for Vortex Razor HD 4000
- Page 2 Accuracy: ± 0.5 yards at 5-199.9 yards display. The Razor HD 4000 also has a LOS (Line of Sight) ± 1 yards at 200-1,000 yards range mode and scan feature.
-
Page 3: Basic Operation
Adjustable condition – the normal power-off Eyecup condition when not ranging. To Install battery with positive side facing outwards. power up the Razor HD 4000 from ready condition and prepare Lanyard Utility Clip for ranging, press and release the Attachment Sockets Measure button. -
Page 4: Mode Selection
Adjust the Eyecup MODE SELECTION The eyecup on the Razor HD 4000 twists up and down The Razor HD 4000 is factory set to the angle compensating ® ® so any viewer can see the full field and enjoy comfortable HCD range mode, normal target mode, brightness level 4 and viewing and ranging –... -
Page 5: Display Selection
To exit Mode/Display Selection and save settings, press and Yards/Meters selection screen. hold the Menu button for four seconds. Settings will also save when the Razor HD 4000 powers down automatically. Display Selection Choose between Yards and Meters Display After activating the Mode... -
Page 6: Normal Mode
Normal Mode Note: If unsure about the range, simply release the measure Your Razor HD 4000 comes preset to normal target mode. button and range again. This is the standard mode providing the range of the target with the strongest range result. - Page 7 SETTING AND USING TARGET MODES RANGING IN NORMAL MODE While in ready condition, cycle between target modes by With the Razor HD 4000 powered up, ® pressing and releasing the Menu button. Once a target position the reticle on the target object mode is selected, press the Measure button to activate the and press and release the Measure target mode.
- Page 8 RANGING MODE EXPLANATIONS Using the HCD Mode The Razor HD 4000 provides two range modes: HCD • Use the HCD range mode in the following situations: ® (Horizontal Component Distance) and LOS (Line of Sight). • Rifle shooting on level ground at any range. Both modes offer a Scan feature.
- Page 9 LOS Mode LOS Mode - Incline The LOS (Line of Sight) mode is intended for rifle shooters When in LOS mode, an additional number is displayed who are using slope correcting ballistic drop data cards, above the yardage number. This number is slope incline ballistic cell phone applications, or other devices with shown in degrees.
-
Page 10: Maintenance
SCAN RANGING LANYARD The lanyard provides a secure The Scan feature can be used to range moving targets or way to carry your rangefinder. help range smaller targets on uniform backgrounds, and works in both ranging and target modes. Once powered up, press and hold the Measure button and scan back and Loop lanyard through forth, watching for changes in the yardage number as the... -
Page 11: Fcc Requirements
RANGEFINDING TIPS FCC REQUIREMENTS The user’s manual or instruction manual for an intentional or • Light colors will usually reflect better than dark ones. unintentional radiator shall caution the user that changes or • Be aware that snow, rain, and fog will have adverse effects modifications not expressly approved by the party responsible for on ranging ability. - Page 12 AND 1040.11 EXCEPT FOR DEVIATIONS PURSUANT TO LASER NOTICE NO.50 DATED JUNE 24, 2007. Lifetime Warranty Sheltered Wings, Inc. One Vortex Drive, Barneveld, Wl 53507 October 2018 Learn more at www.VortexOptics.com CAUTION—Use of controls, adjustments or performance of procedures other than those specified herein may result in service@VortexOptics.com •...
- Page 13 M-00245-0 © 2018 Vortex Optics ® Registered Trademark and TM Trademark of Vortex Optics...