Advertisement
© 2011 KidKraft, LP
Prior To Use:
Pull tag
- Locate the Battery Compartment underneath track
pieces:
(BCS, BTS).
- Pull the tag outward to remove and activate play mode.
- One (1) 3 volt CR2032 Battery is included in each track.
Step 3
Limited Edition Roundhouse Train Set & Table
Instructions for Use:
Battery Tips:
- Batteries should always be installed and changed under adult
supervision.
- Non-Rechargeable batteries are not to be recharged.
- Rechargeable batteries are only to be charged under adult supervision.
- Only batteries of the same equivalent type as recommended are
to be used.
- Batteries are to be inserted with the correct polarity.
- Exhausted batteries are to be removed from the toy and
disposed of properly.
- The supply terminals are not to be short circuited.
- DO NOT mix old and new batteries.
- DO NOT mix alkaline, standard (carbon-zinc) or rechargeable batteries.
- Rechargeable batteries are to be removed from the toy before being
charged.
Battery Instructions
To replace battery:
BCS, BTS
Step 1
Triggers
- Locate the Battery Compartment underneath
the plastic track pieces (BCS, BTS).
- Using a Phillips Head Screwdriver (not
included) remove battery box cover and set
aside.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device,pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio /TV technician for help.
Item # 17967
Step 2
Customer Service
1-800-933-0771
www.kidkraft.com
6
Advertisement
