Additional Installation Requirements; Housing - ZyXEL Communications Prestige 316 User Manual

Prestige 316 Broadband Sharing Gateway / Wireless LAN
Step 4. Connecting the Power Adapter to Your Prestige
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige.
CAUTION: To prevent damage to the Prestige, first make sure you have the
correct AC power adapter. Please see the Appendices for AC power adapter
Step 5. Powering On
You can now power on your Prestige.
NOTE: The two ports of the Prestige on the LAN side (Ethernet LAN and Wireless
LAN ports) can transparently communicate with each other since there is
2.3

Additional Installation Requirements

In addition to the contents of your package, there are other hardware and software requirements you need
before you can install and use your Prestige. These requirements include:
1. A computer with an Ethernet NIC (Network Interface Card) installed.
2. A computer equipped with communications software configured to the following parameters:
♦ VT100 terminal emulation.
♦ 9600 Baud.
♦ No parity, 8 Data bits, 1 Stop bit, Flow Control set to None.
3. A cable/xDSL modem and an ISP account.
After the Prestige is properly set up, you can make future changes to the configuration through telnet
connections.
2.4

Housing

Your Prestige has rubber pads that fit snugly into grooves, enabling compact, sturdy stacking with airflow
between routers. You should not stack more than 4 routers for maximum stability.
NOTE: To keep the Prestige operating at optimal internal temperature, keep the
bottom, sides and rear clear of obstructions and away from the exhaust of other
2-4
specifications for your region.
bridging function between the two ports.
equipment.
Hardware Installation and Initial Setup