Reset Impact Matrix - HMS Networks Ewon Flexy 205 Installation Manual

Resetting the Flexy 205
6. Check if the auto test is successful, the USR LED blinks red following a pattern of 200ms ON
and 1,5 sec OFF. The Flexy 205 does not restart in normal mode by itself and remains in this
diagnose mode.
7. Power the Flexy 205 OFF and ON again to reboot the unit in normal mode. As described
before, the Flexy 205 returns to its default COM parameters and factory IP addresses
(default LAN IP: 10.0.0.53) after this second level reset is performed.
If a different pattern than the successful auto test one is displayed then this pattern reflects an
issue.
The pattern starts with 200ms ON (beginning of the pattern) followed by OFF and a certain
number of times 1 sec ON which allows to identify the nature of the detected problem. Please
write down the observed pattern and contact the local distributor referring to the pattern error.
7.4

Reset Impact Matrix

Impact Reset Level 1
User Reset
Impact Reset Level 2
Factory Reset
Flexy 205 Installation Guide
Erased or Reset
User(s)
adm password
Tags
IO Server config
Gateway config
Ewon Identification
User Web site
User Scripts
LAN IP address + mask
Internet access
Language settings
COM settings (modem, etc)
Talk2M config + key
Proxy configuration
Memory configuration
User(s)
adm password
Tags
IO Server config
Gateway config
Ewon Identification
User Web site
User Scripts
Preserved
LAN IP address + mask
Internet access
Language settings
COM settings (modem, etc)
Talk2M config + key
Proxy configuration
Memory configuration
Nothing
IG-0028-00 1.3 en-US
24 (32)