Table of Contents
Advertisement
IP Address & Access to the Web Configuration
6
IP Address & Access to the Web Configuration
6.1
Factory Default IP Settings
Characteristics
LAN IP address
LAN subnet mask
Gateway
The WAN IP address is set by default in DHCP mode.
6.2
Powering On
Power the unit on and wait approximately 25 seconds until the boot process is completed.
After a successful boot process the USR LED is blinking green slowly.
If the USR LED is blinking red according to a given pattern, it indicates an interruption of the boot
process due to a problem. The most frequent issue is:
•
a duplicate IP address was detected on the LAN network: USR LED blinking pattern is red 1x
short, 1x long
For other LED patterns in case of error, please refer to General Reference Guide from the
Documents, p.
6.3
Connecting to the LAN IP Address
Establish the first communication with the Flexy 205 by using Ewon companion tool eBuddy
which can be downloaded from www.ewon.biz/support.
Connect the LAN port #1 of the Flexy 205 to the computer point-to-point or through a network
provided the default IP address of the Flexy 205 will not conflict with another connected device.
Start the eBuddy application. The application scans through the Ethernet adapter network and
retrieves the connected Ewon devices displaying the IP address, subnet mask and serial number.
The utility also allows the modification of the default IP address without being necessarily in the
same network range. To do so, follow this process:
1.
Start the eBuddy utility
2.
Optional: Highlight the row representing the device which IP address needs to be modified
3.
Click on the button "Set IP" from the top bar menu or hit F2 keyboard shortcut
4.
If step 2 has been fulfilled, the serial number of the selected device appears in the new
popup. If not, indicate the serial number of the device that needs to be modified. Click Next
5.
Indicate the new IP address and its subnet mask. By clicking Next, eBuddy sends the
command to the device to change its IP address and to reboot
6.
Wait until the reboot has ended to reach the Flexy 205 on its new IP address
6.4
Web Interface
While the computer is connected to a LAN port of the Flexy 205, open an Internet browser and
reach the Flexy 205 web server which URL is the LAN IP address of the Flexy 205 (default is
10.0.0.53).
Flexy 205 Installation Guide
3.
Values
10.0.0.53
255.255.255.0
0.0.0.0
21 (32)
Related
IG-0028-00 1.3 en-US
Advertisement
Table of Contents
