Table of Contents
Advertisement
6.31
NEVER attempt to unclog either the auger drill bit while the engine is running.
Immediately shut off the engine. Allow the auger drill bit to come to a complete stop.
Remove the clogged material. Inspect for damage and check for any loose parts for
repair or replacement.
6.32
Whenever you leave the operating position or if you have to remove
processed material, leaves or debris from the machine, You MUST always shut
down the engine, disconnect spark plug HT lead cap, keeping them away from the
spark plug to prevent accidental starting, and wait for all moving parts to come to a
complete stop.
.
6.33
ALWAYS stop the engine before moving the machine.
6.34
You MUST keep all combustible materials and substances away from the
engine when it is hot.
6.35
NEVER cover the machine while the engine or exhaust are still hot.
6.36
NEVER operate the machine on slopes.
6.37
Move the machine at least 3m away from the refuelling point before starting
engine.
6.38
ALWAYS check the fuel/oil mixture level of the engine before use.
6.39
Inspect that all nuts and bolts are tight and well connected to ensure the
safety and reliability of this machine prior to any operation.
6.40
After allowing the engine to warm up before operation.
6.41
If the machine jams you MUST release the throttle and move the auger drill bit
before re-commencing work.
6.42
To remove blockages DO NOT under any circumstances use your hands.
6.43
Stop and disable the machine by removing the HT lead plug cap.
6.44
Clear the auger drill bit of materials which have become stuck to the auger bit.
17
Advertisement
Table of Contents
