Table of Contents
Advertisement
7. USING THE MACHIINE
WARNING
You MUST STOP using the machine if any of the following occur.
The engine speed changes with no control.
In case of misfire
In case of high vibration.
When flames or smoke appear.
In rain or adverse weather conditions.
CAUTION
If you are not familiar with this type of machine you should seek advice and
guidance from your dealer.
DO NOT attempt to lift or move the machine while the engine is running.
6.0
Make sure you always have a secure footing and good balance when using the
machine.
6.1
Always hold the auger firmly with both hands on the handles.
6.2
The auger is designed to be operated by one person only.
6.3
DO NOT allow other people or animals in the work area when the tool is in operation.
6.4
Position the machine is such a way that it cannot move during use, maintenance,
cleaning, adjustment, assembly of accessories or spare parts, as well as under
storage.
6.5
DO NOT force the machine. Use the correct machine for your application.
The correct machine will do the job better and safer t the rate for which it is
designed.
6.6
DO NOT change the engine governor settings.
If the engine speed is too high it will cause excessive wear.
If the engine speed is too low the auger will not drill holes effectively.
6.7
Check and adjust the idle speed setting regularly.
If the auger bit continues to rotate when the engine is at idle, have it checked
by your service dealer.
6.8
Only ever start and stop the machine as outlined in this user manual.
6.9
DO NOT place excessive body weight on the auger.
This machine will operate better with a shaving action caused by the weight of the
auger itself.
6.10
NEVER run the engine indoors or in enclosed spaces. Exhaust fumes can be fatal.
6.11
In the event of imminent danger or in an emergency, switch off the engine immediately.
6.12
DO NOT run the engine at high speeds when not in use.
6.13
Avoid contact with hot fuel, oil, exhaust fumes and hot surfaces.
15
Advertisement
Table of Contents
