Installation Procedures - Faber SOTTILE SLIM Series User Manual

3. INSTALLATION PROCEDURES

1. All the plumbing works should be completed
before proceeding to electrical wiring connection.
2. INLET and OUTLET connection of the heater unit
should not be reversed, with stop valve installed on
INLET. (Diagram 1)
3. It is recommended that the unit should be mounted
above 1.5m or 5-feet above the floor to bottom of
the heater. (Diagram 1)
4. Mark mounting position (Diagram 2)
• Remove screw at the bottom of the heater
• Lift the plastic cover upward
• Mark mounting position on the wall
• Drill the holes with 5.0mm diameter drill bit
• Install the unit to the wall with plug
5. Heater INLET and OUTLET Connection (Diagram 3)
a) Connect the stop valve to INLET, and be sure to
put a gasket to prevent water leakage.
b) Connect the piping from the stop valve to incoming water supply. If necessary,
make use of sealing tape for the connection to prevent water leakage.
c) Connect flexible hose to heater OUTLET. Turn on the water mains to drain out all
the plumbing dirt and fill up the heater tank. Then, connect the flexible hole to the
hand shower.
(Note: This step will prevent damage to the heating element).
Stop Valve
Inlet
correct installation
SAFETY PRECAUTION
Do not install reverse INLET and OUTLET of heater
Outlet
inlet - outlet reverse
(wrong installation)
Diagram 3
incoming
stop
valve
Inlet
Outlet
7
stopvalve
water
INLET OUTLET
stop
valve
Outlet
Inlet
stop valve reverse
(wrong installation)