Advertisement
D represents the wall-mounted distance between holes of horizontal, E represents the
wall-mounted distance between holes of vertical.
2.4 Internal Wire Diagram
Thermal
Cut Out
L
N
E
WIRING DIAGRAM FOR FSH DUAL D**VH
3. UNIT INSTALLATION
3.1 Installation Instruction
①
This electrical water heater shall be installed on a solid wall. If the strength of the wall cannot
bear the load equal to two times of the total weight of the heater filled fully with water, it is
then necessary to install a special support.
Incase of hollow bricks wall, ensure to fill it with cement concrete completely.
②
After selecting a proper location, determine the positions of the two install holes used for
expansion bolts with hook (determined according to the specification of the product you
select). Make two holes in the wall with the corresponding depth by using a chopping bit with
the size matching the expansion bolts attached with the machine, insert the screws, make
the hook upwards, tighten the nuts to fix firmly, and then hang the electric water heater on it
(see Fig.2).
NOTE
Thermostat
ON/OFF
5
Advertisement
