3. UNIT INSTALLATION
3.1 Installation Instruction
①
Check the capacity of power circuit;
②
Power cord installation;
③
Water heater installation;
!
Minimum conductor sizes
Live: 4mm²
Neutral: 4mm²
3.2 Power Cord Installation
Step 1
Remove the screws at the bottom of the unit. Lift
up the Main Switch Knob and Power Knob to
make it free. Remove the front plate gently.
Step 3
Gash the middle of the film of the power cord
jacket with a sharp knife in order to put into
power lines.
Step 5
Tighten the wire-pressing plate with screws to
primary position, ensure that the power cord not
be pulled out more than 60N.
④
Plumbing connection;
⑤
Power supply connection;
⑥
Water Supply.
WARNING
PE: 4mm²
Step 2
Remove the power cord wire pressing plate and
keep the screws.
Step 4
Screw the power cord into the jacket for
installation of wire pressing plate.
Step 6
Connect the power cord to wiring terminals; the
method is as shown in picture.
6