Faber SOTTILE SLIM Series User Manual page 8

6. Electrical Connection
a) Insert electrical cable through the rubber
grommet as shown.
b) Connect the cable to the terminal block
and fully tighten them as the following:-
• Red or Brown........................................ Live (L)
• Black or Blue.......................................... Neutral (N)
• Green or Green/ Yellow....................... Earth
c) Restore the cover and secure screw at the bottom. (Diagram 4)
d) Align the knob, from 'OFF' position in clockwise direction
to 'MAX' and return to 'OFF' mark as shown (Diagram 5)
Test Run Of Heater:
a) Turn on the stop valve and water should spray out from shower head.
b) Switch on the main power supply ("POWER" LED would light up).
c) Turn on the Temperature Control Knob and 'HEATER' LED would light up.
The water should be warmed in a few seconds.
d) Turn on the Pump Control Knob to accelerate water flow.
(For Pump model only)
e) Test the ELCB by pressing 'TEST' button. The unit should be tripped.
'POWER' and 'HEATER' LEDs would light off.
f) Press 'RESET' button, The unit should resume to normal condition.
g) The heater is now ready for use.
STEP 1
Diagram 5
8
STEP 2
Restore cover
Diagram 4