Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Faber PEBBLES Series
Summary of Contents for Faber PEBBLES Series
- Page 1 PEBBLES SERIES PEBBLES 106WH PEBBLES 107BK INSTRUCTION MANUAL...
-
Page 2: Safety Precaution
Thank you for purchasing FABER Instant Water Heater. Please read this manual thoroughly and understand the content before use. SAFETY PRECAUTION LANGKAH–LANGKAH KESELAMATAN Do not install reverse INLET & OUTLET and Stop Valve of heater. Do not install the heater at where there is consistent spray directly over the unit. - Page 3 1. WATER HEATER PARTS IDENTIFICATION EXTERNAL PARTS IDENTIFICATION ABS Heater Base Temperature Control Knob Test & Reset Button Power LED (Green) Heater LED (Red) Stop Valve (Inlet) INTERNAL PARTS IDENTIFICATION ABS Heater Base Electric cable Recommended conductor size: 4.0mm (not included) ELCB Control Board Thermal Cut Out Cabel Entry...
-
Page 4: General Information
2. GENERAL INFORMATION INSTALLATION CAUTION: AWAS: THIS APPLIANCE MUST BE EARTHED PERKAKAS INI MESTI DIBUMIKAN 1. All plumbing work should be completed before proceeding to electrical wiring connection. (Table 1) 2. Installation must be carried out by qualified electrician with close reference to this manual and in compliance with the local regulations. -
Page 5: Installation Procedures
3. INSTALLATION PROCEDURES 1. All the plumbing works should be completed before proceeding to electrical wiring connection. 2. INLET and OUTLET connection of the heater unit should not be reversed, with stop valve installed on INLET. (Diagram 1) 3. It is recommended to mount the unit at 1.5mm above the Stop Valve 1.5m floor to bottom of the hater. - Page 6 6. Electrical Connection Restore cover a) Insert electrical cable through the rubber grommet as shown. b) Connect the cable to the terminal block and fully tighten them as the following:- • Red or Brown ……………………………….……… Live (L) • Black or Blue.……………………………………Neutral (N) •...
-
Page 7: Operation Procedures
4. OPERATION PROCEDURES 1. Switch on the main power supply, the ‘POWER’ LED would light up. 2. Turn on the water supply at the stop valve. 3. Turn on the Temperature Control Knob. The ‘HEATER’ LED would light up and the water temperature will be increased accordingly as the knob is turned clockwise from ‘ON’... -
Page 8: Technical Specification
6. TECHNICAL SPECIFICATION Electrical loading 3.8kW 240V 50/60Hz Other loading Please refer Electrical loading table ELCB sensitivity 15 mA Operating condition Open system (Open outlet) Water connection 15mm (1/2” BSP) Degree of protection IP25 Min water flow rate 2 litre/ min Min water pressure 0.2 bar ( 20kPa / 2.9psi ) Max water pressure...