Internal Switch Settings - Wohler AMP1A Series User Manual

Internal Switch Settings

After removing the top cover, you can access DIP switches that control
level meter settings and/or calibration settings.
AMP1A-30 and AMP1-106 Internal Switch Settings
This 10-position DIP module is located on the 919174 PCB. Refer to
Figure 1–12
positions 1 and 10 are not used and should be left at the factory set
position.)
Figure 1–12
Figure 1–13 on page 18
below for a complete list of settings and functions. (Switch
0-Position DIP Switch Settings
illustrates the DIP switch location on the PCB.
© 2 0 1 0 Woh l er Te c h n o l o g i es , I n c . A ll r i g h t s r e se r ve d .
AMP1A Series User Guide
I n te rn al S wi t ch S e t t in g s
8 2 1 0 2 0 : A M P 1 A S e r i e s U s e r G u i d e
17