TEC FS-1450 Owner's Manual page 15

There are the following two ways of receipt paper feed procedure.
6
A: Manual installation
B: Installation using the [RF] key
A: Manual installation
B: Installation using the [RF] key
5
1 Lift the green lever on the receipt side.
- 9 -
Place the paper roll in the outer side holder of
the two roll holders.
2
Insert paper from the rear of the printer
until the leading edge of paper comes out
by 10 cm.
3
Lower the green lever.
4
Attach the receipt cover.
1
Insert paper from the rear of the printer
until it won't go no further.
2
Press the [RF] key to feed paper until the
leading edge of paper comes out by 10
cm.
3
Attach the receipt cover.
EO1-11097