Installing The Journal Roll - TEC FS-1450 Owner's Manual

Installing the Journal Roll

1
Follow Steps 1 to 5 for "Installing the Receipt Roll" on the preceding pages, except that
the paper roll should be placed inner side holder of the two holders.
2
There are the following two ways of a journal paper feed procedure.
A: Manual installation
B: Installation using the [JF] key
A: Manual installation
B: Installation using the [JF] key
1
Lift the green lever on the journal side.
2
Insert paper from the rear of the printer until
the leading edge of paper comes out by 30
cm.
3
Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
4
Place the take-up reel on the take-up holder.
5
Lower the green lever.
6
Attach the receipt cover.
1
Insert paper from the rear of the printer until
it won't go no further.
2
Press the [JF] key to feed paper until the
leading edge of paper comes out by 30 cm.
3
Insert the leading edge of paper into the slit
of the take-up reel to take up paper two or
three times.
4
Place the take-up reel on the take-up holder.
5
Attach the receipt cover.
- 10 -
EO1-11097