PANCONTROL PAN 3000A+ Manual page 26

Automatic/Manual Range selection
When the meter is switched on, it is in the auto ranging mode. The device
automatically detects the appropriate measuring range. Manual range
selection is not possible.
Data hold
If the reading could not be read during measurement due to difficult operation
the „HOLD"-button (4.2) could be pressed to freeze the display reading. Press
the „HOLD"-button to freeze the display reading. The "H" symbol appears in
the display. Press the „HOLD"-button again to return to standard operation.
Backlight
To turn the backlight on or off, press the button (4.1).
Point Illumination
In low light conditions, you can illuminate the point. To do this, press the
button (4.3).
Auto power off
If no further measurements are carried out, the device switches off
automatically after 5 minutes.
DC Voltage measurement, AC Voltage measurement, Resistance
measurement and Continuity test
The device detects DC voltage, alternating voltage or resistance automatically.
Alternating current is detected via the flexible pliers.
(Sequence: AC voltage, DC voltage, AC current, resistance / continuity test)
DC voltage: If the polarity is reversed a "-" is displayed.
AC voltage / current: When measuring alternating voltage/alternating current,
the frequency is displayed in the secondary display.
EN 9