Harmony Assembly Of Components; Wheelbuilding - NuVinci Harmony 330 Owner's Manual

6. Harmony assembly of components

6.1 Wheelbuilding

• The anti-shift retainer (A) provides 135mm
spacing, and should remain on the CVP
during lacing and wheelbuilding.
- Maximum spoke diameter is #13/ 2.34mm
- Minimum spoke diameter is #14/ 2.00mm
• Suggested lacing is a 2-cross pattern for 26
inch and 700c wheels.
- Use a 2-cross pattern only if the rim allows
the nipples to be effectively in-line with the
spokes.
• For 24 inch or smaller wheels a 1-cross
pattern is suggested.
• Radial lacing is not recommended.

Installation and repairs must be made
!
by a qualified bicycle mechanic.
 This section assumes a level of
!
knowledge and skill consistent with
that of an experienced bicycle
assembler or bicycle mechanic.
TECHNICAL OWNER MANUAL
135 mm
A
HARMONY ASSEMBLY OF COMPONENTS
EN
11