Using the SCANNER key to begin scanning
•
Scanning is not possible during a copy job.
•
If the unit is used to begin a scan job during a print job, the scan job will be stored and
scanning will begin when the print job is completed.
1
Press the SCANNER (
The unit enters scan mode.
2
Place the original you wish to scan on the original table.
For the procedure for placing the original, see "ORIGINAL PLACEMENT" (page 3-5)
3
Press the up copy quantity key to display the number
of the application that you wish to use for scanning.
The application numbers are initially as follows.
Application number Application launched
SC1
SC2
SC3
SC4
SC5
SC6
7-22
INSTALL THE SOFTWARE
) key.
Desktop Document Manager (if installed)
E-mail (your standard e-mail program in the Windows OS you are using)
Fax (if a fax program is installed)
OCR (if an OCR program is installed)
Microsoft Word (if installed)
Any application set in Button Manager