Toshiba 120/150 Operator's Manual page 57

• If you are using the parallel interface connection, do not select the Button Manager
checkbox because this feature is not supported with the parallel interface.
• If the following screen appears, click the "OK" button. Review the contents in See
"BEFORE INSTALLATION" (p.7-3), and then select only appropriate the software
packages to be installed.
5
Review the software packages to be installed on
the screen, and then click the "Start" button.
The software packages to be installed will be displayed
on the screen. If inappropriate packages are displayed,
click the "Back" button to select appropriate packages
again.
6
Copying files for MFP driver installation (This step will start if it was selected in step 4).
1. After confirming the message in the "Welcome" window, click the "Next" button.
2. A dialog box appears asking you to verify that the USB or parallel interface cable is not connected
to the MFP. Make sure that the interface cable is not connected and click the "Next" button.
3. Click the "Next" button in the dialog box to install the
MFP driver or Cancel to quit the installation.
• The setup program will start to copy the files.
• If the following screen appears while the files are
being copied (the message may appear more than
once), click "Continue Anyway".
4. When the "The MFP driver installation is complete." dialog box appears, click the "OK" button.
• The Button Manager installer will start.
7-6
INSTALL THE SOFTWARE