Future light EYE-18 Quick Manual page 3

Control Board
Main
Sub menu
menu
ADDR
RUN
0 MODE
DISP
RPAN
RTIL
16BI
1 SET
REST
LODA
VER
MATI
2 TIME
CLMT
STEP
SC01
3 EDIT
SC48
Stand Alone operation
In the Stand Alone mode, the EYE-18/EYE-36 can be used without controller.
Disconnect the EYE-18/EYE-36 from the controller and call the internal program.
1. Press [MODE/ENTER] button to enter the main menu "MODE" (display flashing)
2. Press [MODE/ENTER] and select "RUN" by pressing [UP] button.
3. Press [MODE/ENTER] and select "AUTO" by pressing [UP] button.
4. Press [MODE/ENTER] and select "ALONE" by pressing [UP] button.
5. Press 3 x [EXIT] to confirm, the display shows "AU-A".
Please refer to the instructions under Control Board, Main functions, menus Run and Edit.
FUTURELIGHT EYE-18/EYE-36
Quick Guide
Extension
VALU
SLAV
AUTO
SOUN
VALU
RDIS
CLDI
ON/OFF
ON/OFF
ON/OFF
ON/OFF
ON/OFF
V-1.0~V-9.9
0000~9999 (hours)
ON/OFF
S–01 ~ S–48
C01 ~ C30
~
TIME (sec.)
CNIN
Display
A001~A511 (AXX)
ON/OFF (SLAV)
ALON (AU-A)
MAST (AU-M)
ALON (SO-A)
MAST (SO-M)
D-00 ~ D-30 (DXX)
D-00
ON/OFF
ON/OFF
01XX (00~FF)
30XX (00~FF)
T – – X (1~9)
ON/OFF
Function
DMX address setting
Slave setting
Automatic Program Run
in Stand Alone
Automatic Program Run
as Master
Sound-controlled Program
Run in Stand Alone
Sound-controlled Program
Run as Master
Display the DMX 512 value
of each channel
Reverse display
Shut off LED display
Pan Reverse
Tilt Reverse
Switch 16 bit/8 bit
Reset
Restore factory settings
Software version
Fixture running time
Service-function
Steps of Program Run
Edit the channels of each
scene
Time for each scene
Edit program via controller