Next steps
1. Connect the battery cable to the connector on the system board.
2. Replace the
base cover
3. Replace the
SD memory card
4. Follow the procedure in
Coin-cell battery
Removing the coin-cell
Prerequisites
1. Follow the procedure in
2. Remove the
SD memory card
3. Remove the
base cover
4. Disconnect the battery cable from the connector on the system board.
Steps
1. Using a plastic scribe, gently pry the coin-cell battery out of the slot on the I/O board [1].
2. [2].
Installing the coin-cell battery
Steps
1. With the positive-side facing up, insert the coin-cell battery into the battery socket on the I/O board [1].
2. Press the battery until it clicks into place [2].
after working inside your computer
before working inside your computer
Removing and installing components
25