Advertisement
HS2000X(R)instructions
Installation:
Choose position carefully for mounting the appliance,
G
space must be left around appliance. NOTE: It is NOT permissible to
install this heater in Zones 1 or 2. Please install it outside Zone 2 in the
undesignated area – see Figure 1 above.
G
The heater must be mounted at a high level – see opposite.
G
Loosen the two screws at the top of the front of the heater and lift off
the front cover.
G
Drill two 8mm holes on the wall at a distance of 190mm on a
horizontal line, another one at a distance of 115mm down from the
horizontal line.
G
Insert the three plastic plugs into the three holes, and then screw two of
the screws provided into the lower holes. Do not screw these two screws
fully home as the heater will hang on them later. As a guide they need
to be left protruding by about 3mm
G
Hang the heater on the two screws. It may be necessary to mount and
dismount the heater a few times, slightly tightening and/or loosening
the screws as required, to ensure a snug fit.
15/8/14
10:33
Page 4
THE APPLIANCE IS DESIGNED ONLY FOR WALL MOUNTING
4
Figure 1
RCD protected
RCD-protected
sockets now
sockets now
allowed beyond
allowed beyond
3m from Zone 1
3m from Zone 1
.
enough
Advertisement
