Standard Operation Options - Key Automation 900CT-1AR Instruction Manual

STANDARD OPERATION OPTIONS

JUMPER 1
DIP SWITCH 1
DIP SWITCH 2
DIP SWITCH 3
DIP SWITCH 4
JUMPER
MEMORYBLOCK
FLASHING UNIT/COURTESY LAMP FUNCTION
This enables the user to select whether to enable the output
for a flashing unit or that of a courtesy lamp (which turns off 3
minutes after door movement).
NORMAL/APARTMENT BLOCK OPERATION
This selection enables the user to change from the standard
operation of step mode (open stop close) to an open-only command.
PHOTOCELL PAUSE ON OPENING FUNCTION
This selection enables the user to change the standard photocell
operating mode. During the opening phase, if the beam is interrupted
the door stops and when the photocell beam is restored the door
resumes opening. During the closing phase, if the photocell beam
is interrupted the door stops and when the beam is restored the door
inverts movement to open again.
AUTOMATIC CLOSING DISABLE FUNCTION
This selection enables the user to disable the automatic closing
function. On completion of opening the door is not set to pause status
for the set time, but remains stationary on standby for a ne close
command.
WORKING TIME EXTENSION FUNCTION
This selection enables the user to double the working time of the
door from the setting of 60 to 120 sec.
SELECTION MEMORYBLOCK
With insert jumper i is not possible to memorize transmitter
10
GB
O N
F
O F
4
2 3
1