Fisher & Paykel RB2470BRV Installation Manual page 25

Hanging the door panel
Open the refrigerator door.
!0
Hang the top door panel onto the height
!1
adjustment nuts (E) at the top of the
refrigerator door.
Align the bottom attachment
!2
brackets (F) with the screw
holes at the bottom of the
top door panel. Fasten with
cabinetry attachment screws
(G) and wood screws (H).
– Do not tighten fully to
allow adjustment of the
top door panel.
Bottom view of door
!9 INSTALL TOP DOOR PANEL (CUSTOM)
E
F
H
G
Adjusting the door panel
Height adjustment of the door panel
!3 Turn the height adjustment nuts (H) with a hex key.
– We recommend to use a T-handle hex key so that the height adjustment nuts can be
turned easily without being blocked by the magnet sensor.
– If the height adjustment nuts cannot be adjusted, check the left and right clearances
of the top hanging bracket.
Side adjustment of the door panel
Move the door panel slightly sideways to adjust
!4
the side alignment.
!5 Screw the side adjustment nuts (I) onto the
thread of the height adjustment nuts to secure
the door panel to the refrigerator door.
Depth adjustment of the door panel
Loosen the depth adjustment nuts (J) and move
!6
the door panel forward/backward to adjust the
depth position.
!7 Tighten the nuts fully after you are satisfied with
the adjustments.
Fixing the top door panel
Once you are satisfied with
!8
the adjustment, fully tighten
the screws of the bottom
attachment brackets (K) to
secure the door panel.
Place the bracket covers
!9
on the bottom attachment
brackets (L).
SCALE 2:1
H
J
I
I
K
L
23