Fisher & Paykel RB2470BRV Installation Manual page 22

Adjusting the door panel
Height adjustment of the door panel
Turn the height adjustment nuts (H) with a hex key. Hold the side adjustment nuts (J) in
!1
place with a spanner to ensure it does not rotate when turning the height adjustment nuts.
– We recommend to use a T-handle hex key so that the height adjustment nuts can be
turned easily without being blocked by the magnet sensor.
– If the height adjustment nuts cannot be adjusted, check the left and right clearances
of the top hanging bracket.
Side adjustment of the door panel
Move the door panel slightly sideways to adjust the side alignment.
!2
Screw the side adjustment nuts (I) onto the thread of the height adjustment nuts to secure
!3
the door panel to the refrigerator door.
Depth adjustment of the door panel
Loosen the depth adjustment nuts (J) and move the door panel forward/backward to
!4
adjust the depth position.
Tighten the nuts fully after you are satisfied with the adjustments.
!5
Repeat steps – for the door panel of freezer door.
!1 !5
Note: The magnet sensor is installed only on the refrigerator door.
20
!8 INSTALL DOOR PANELS (STAINLESS STEEL)
H
I
Fixing the top door panel
Once you are satisfied with the adjustment, fully tighten the screws of the bottom
!6
attachment brackets (K) to secure the door panel.
J
Repeat step for the door panel of freezer door.
!6
L