Removing the hanging bracket
1
Open the refrigerator door and
remove the top hanging bracket
cover by drawing out upwards.
2
Pull out the rulers from the
internal slots of the top
hanging bracket and turn the
rulers around.
Insert the rulers into the
3
external slots of the top
hanging bracket with the
overhang of the rulers
pointing outward.
!9
INSTALL TOP DOOR PANEL (CUSTOM)
Refrigerator door
External slots
4
Push the rulers down so that
the underside of the overhang
of the ruler is flush with the
top of the cabinetry (A).
Note:
If there is an existing
●
●
compartment on top of the
cabinetry, push the rulers so
that the overhang of each
ruler contacts the bottom of
compartment front panel (B).
The overhang creates a 1/8"
●
●
(3mm) gap between top and
bottom door panels.
Internal slots
Remove the two side adjustment
5
nuts (C) on the top hanging bracket
using a spanner, then remove the top
hanging bracket and rulers together.
– Ensure the rulers are kept
in place as you remove the
hanging bracket.
– Keep the hanging bracket to
reinstall later.
Top of cabinetry
Flush
A
Ruler
Side view
Compartment
front panel
1/8" (3mm) gap
B
Side view
Top hanging
bracket
C
Refrigerator door
21