Alarm Signals; Status Display Permanently Red - UseTECH FlowTimer+ Protect Set Operating Manual

Troubleshooting, Maintenance
9.2

Alarm signals

Red (duration)
03/19
9.2.1

Status display permanently red

The hot water supply was automatically interrupted by
FlowTimer+ Protect.
 An alarm via the I/O port has caused the FlowTimer+
Protect to shut off or the Hub to Protect connection
cable is faulty.
Examination:
 Check the status display of the FlowTimer+ Hub and the
connected individual FlowTimer+ as well as the connection
cable between Hub and Protect (please use the instructions of
the respective products).
The I/O connection cable incl. the plug connections
between Hub and Protect are monitored by the
electronics as well! If the FlowTimer+ Protect is supplied
with power and this connection is disturbed, it is shut off
for safety reasons.
An operation of FlowTimer+ Protect is not necessary,
because an alarm as well as its resetting is done
automatically by the upstream FlowTimer+ systems.
FlowTimer+ Protect Set 22