Checking The Hot Water Preparation - UseTECH FlowTimer+ Protect Set Operating Manual

Getting Started
7.1

Checking the Hot Water Preparation

03/19
 Setting the water heater to the maximum permissible
temperature and preparing hot water
 Open the hot water pipe and test for hot water leakage.
 Pull the pressure sensor plug on the FlowTimer+ and interrupt
the cold water supply.
 The status display of the FlowTimer+, FlowTimer+ Hub
and FlowTimer+ Protect must now be permanently red!
 At the moment of the interruption of the cold water section, it
must no longer be possible to detect that the hot water circuit is
running after the cold water section.
CAUTION
If warm water is added, there is a risk of scalding!
 Disconnect the power supply to FlowTimer+ and
FlowTimer+ Protect to prevent possible shut-off.
 A technician needs to take a closer look at your
installation.
 The system is then not ready for operation until
clarification!
FlowTimer+ Protect Set 17