Table of Contents
Advertisement
Installation
6.5
Electrical connection
03/19
Never use tools to lever between the valve and the
FlowTimer+ electronics! (danger of destruction)
If the I/O plug is plugged into the socket, this must cause
a clicking noise. If not, please check again whether the
plug is correctly engaged!
When disconnecting connections, please note to press
the locking lugs of the I/O connectors!
Connect the FlowTimer+ Hub to the I/O port (14) of the FlowTimer+
Protect using the I/O connection cable.
Plug the power supply unit into a suitable socket and connect the
power supply unit to the power supply connection (18) of the
FlowTimer+ Protect.
The I/O connection cable incl. the plug connections
between Hub and Protect are monitored by the
electronics as well!
If the FlowTimer+ Protect is supplied with power and this
connection is disturbed, it is shut off for safety reasons.
The I/O connections between the individual FlowTimer+ and the
FlowTimer+ Hub are not monitored to easily find a possible single
alarm in the alarm group.
FlowTimer+ Protect Set
15
Advertisement
Table of Contents
